Connecting the battery
VEHICLE SETUP
12
Fault
Possible Reason
Drivetrain fault Solution
The motor suddenly stops running
while in working state.
The throttle signal is lost.
Motor is cogging when accelerated
quickly.
Check the drivetrain of the vehicle.
Check the transmitter and the receiver.
Check the throttle wire connection.
Check the settings.
Set D/R, EPA, ATL to 100% or turn the
knobs to maximum value.
Set TRIM to 0 or turn the knob to its
neutral position.
Replace the battery pack, or cool
down the ESC.
Use battery with better discharge
ability.
The battery has limited discharge
ability.
The transmitter is improperly setup.
Low voltage cut-off protection or
Over-heat cut-off protection has
been activated.
Motor RPM is too high, the gear ratio
is too aggressive.
Use motor with lower RPM, or use
smaller pinion to get softer gear ratio.
Something wrong in the driving
system of the car.
The model cannot reach its
maximum speed and the red LED
does not become solid at full
throttle.
STEP 2: Lift the vehicle body and place the brace rod
between the chassis and body.
STEP 3: Place the battery in the battery box then
connect the battery plug (T-plug or XT60 plug).
STEP 1: Release the two body clips.
EN
Summary of Contents for DPROC001RS
