Página
16
de
24
2.5. Authorized fuel. The apparatus must not be used as an incinerating device.
Only logs of
natural wood are recommended, humidity within 12 and 20 % . It is highly recommended the
use of at least 2 year-old logs. The use of other types of fuel is forbidden, as well as any liquid
used to light barbecue fires. Their maximum length might not be longer than 550 mm.
2.6. Loading and reload fuel. It must take into account the maximum authorized load of fuel,
ensuring that when the recharge it does not exceed 175 mm in height.
It is provided with two
rectangular pieces that control the load. The fuel can’t overtake the limit, taking care not to
exceed either in quantity or size to the data specified above.
To make the procedure ignition follow these steps: placing the burden on the central area of the
database from home, open the register primary and secondary maximum and then fire pledge
(USE ONLY FOR THE ELEMENTS TO). Once this fire ignition control its intensity through the
records to get the desired combustion (2.2.). When the fuel load has been reduced should
return to recharge taking into account the specified data above.
2.7. Mechanism blockage. It is compulsory to check any piece because they might get stuck
after a long period of time without using the fireplace. Keep outdoor inlet free from blockage.
2.8. Load opening.
2.8.1. Guillotine opening: in this system, the door move from down to upwards and it is useful
for loading.
2.8.2. Lateral opening: it is useful for cleaning, change the glass or joint, etc. To open the
door: first raise the framework, not much,; in this position raise the piece situated in lateral
(26)
an then the door will be free, now, go down the framework and can open the door
(27).
Repeat
the same steps but in reverse order for close the door.
2.9. Cleaning and maintenance.
2.9.1. Glass cleaning. To clean the glass, the apparatus must not be operating. Do not clean
with any liquid either the metal parts of the door or the seal, in order to prevent damage.
2.9.2. Ash box cleaning. Empty the ash box when the apparatus is totally off. Watch out hot
ash. When doing it, dump the ash into a metal bucket.
2.9.3. Smokestack cleaning. It is necessary to clean the chimney at least once a year. The
only thing to be done is to remove the deflexed panel.
2.9.4. Paint, The exothermic paint lining the inside and outside the appliance supporting up
600°C temperature and shows a slight characteristic odor that disappears early on.
It is also possible that after some time, the paint inside the fireplace wears off due to the liquid
corrosion, fuel or other reasons. In this case, it will be necessary to wear the rusty zones off and
repaint them again.
(Use only the spray “Rocal spray pint 600ºC BLACK – No gris antracita).
2.10. Fire Prevention. No flammable element must be placed the nearest at 1000 mm away
from the fireplace. Special prevention must be taken when children or elderly around.
In case of a fire, move away all people around, close registers and call the Firemen Department.
2.11.Operating the fireplace under certain weather conditions. It is possible that under
certain weather conditions the apparatus doesn’t work properly: smoke mislead or not enough
intake. When observing these phenomena, it is highly recommended to close all air registers
and extinguish the fire.
2.12. Fireplace modification. Any modification must be authorized by means of writing on
behalf of Manufacturas Rocal SA. It is also compulsory to use the spare pieces recommended
by Manufacturas Rocal SA.
3 .
DETECTION OF MALFUNCTION
