Robo-Tank DIY All-In-One Aquarium Controller User Manual
Robo-Tank DIY All-In-One Aquarium Controller
Back to Top
User Manual v4.05 – Page 56
There is no limit how long it takes to complete a step, you can leave the probe in the solution for 20 minutes and press OK,
just be sure to leave it in the buffer solution for more than 2 minutes.
If you selected a 1 point calibration the calibration is complete once you press OK and you’ll see a screen verifying this.
If you selected 2 point or more you’ll be taken to step 2 or 3 after pressing OK. Repeat the above until it tells you the
calibration is complete.
*Remember: always rinse your glass container with RO or distilled water before adding the solution, and only pour
out enough to just cover the probe tip, and swirl the probe around to ensure full contact with the solution and to
get rid of any trapped air.
Warning Message When Updating Calibration Data
Once you press OK, you get the screen to the left,
confirming what you are about to do, and it will
replace any existing calibration data. If you had
followed the suggestion at the beginning, you will
have already pressed Clear Calibration Data, and
there is no calibration data to replace.
Press OK to update the data OR Cancel Calibration
to back out.
