8
Caution in Handling
1. Make sure to follow the usage condition, environment and specification range of
the product.
2. Do not conduct any treatment or operation that is not stated in this instruction
manual.
3. Make sure to attach the actuator properly by following this operation manual.
Using the product with the actuator not being certainly retained or affixed may
cause abnormal noise, vibration, malfunction or shorten the product life.
4. It is recommended to apply our products for the wiring between the actuator and
the controller.
5. Do not attempt to establish the settings for the speed and
acceleration/deceleration above the allowable range.
If the robot is operated at a speed or acceleration/deceleration exceeding the allowable value,
abnormal noise or vibration, failure, or shorter life may result.
6. Set the allowable load moment within the allowable range.
If the robot is operated under a load equal to or greater than the allowable load moment,
abnormal noise or vibration, failure, or shorter life may result. If it is extreme, flaking may occur
on the guide.
7. Make sure to attach the actuator properly by following this operation manual.
Using the product with the actuator not being certainly retained or affixed may cause abnormal
noise, vibration, malfunction or shorten the product life.
8. When putting a cable through the hollow, consider protection to the places
contacting to the output axis such as by putting an adhesive tape for high wear
resistant cable around the cable.
Keeping a cable without protection touching to the rotating output axis may cause a failure such
as abrasion and wire breakage.
9. Pay attention to cable layout when putting cables through the hollowed hole on
the cleanroom type.
It may cause to generate dust due to contact of shaft and cables.
