Robland KM 775, Instruction Manual

Page: 16 / 70

Instructions manual KM 775 - 785
9
3.2 Start-up and stop the machine
To start the machine, turn the main switch to ON. The general voltage pilot lamp
must be illuminated.
BEFORE CARRYING OUT ANY TASK AT OR AROUND THE MACHINE,
MAKE SURE IT IS COMPLETELY STOPPED, THAT IT CANNOT POSSIBLY MAKE
ANY MOVEMENT AND THAT THE MICROSWITCHES CANNOT BECOME ACTIVE:
DO THIS BY PRESSING ANY OF THE EMERGENCY STOPS.

Make sure there is enough glue in the container for the job to be done.

Operate the resistances On selector. (Q3)

Select the desired working stations.

Insert the strip as far as the first pressure roller.

Adjust the height of the presser to suit the panel to be passed through.

When the heating pot temperature reaches the set point figure, reset the machine
by deactivating the emergency stop, then pressing the green reset button. The
motors may now be switched on by pressing the motor On and chain activated
buttons.

The machine is totally stopped by opening the cabin, operating any of the
emergency stops or turning the main switch to OFF.

3.3 Adjusting presser height:
The height of the presser needs resetting every time the thickness of the board to
be edged changes. This simply involves loosening the levers on the presser fixing pads,
and using the lever to raise or lower the presser to the required value as indicated on
the numerical counter.
3.4 Loading and regulating the band in roll form:
To introduce the roll in the tray carries roll in having felt schedule, to go the first
song by the fixation roller, until it surpasses the center of pressure roller. To adjust the
Presser fixing
lever