Robland KM 775, Instruction Manual

Page: 20 / 70

Instructions manual KM 775 - 785
13
5.1.3 Setting up for correct gluing:
If the glue is not evenly dispensed after adjusting and checking the points above,
for example if there are parts on the top without glue, the first thing to check is that the
panel is being cut square. Then check that the scoring disc has not made too great an
incision in the board. If neither of these is the problem, turn the glue pot fixing screws
and slope the station forwards if there is not enough glue on the top, and backwards if
there is not enough on the bottom. In other words, attempt to get the glue roller and
board parallel to each other.
The best way of doing this is first to take the distance between glue nozzle and
the wall of the presser, then to slightly loosen the glue pot fixing screws and slope the
station as necessary. Then retighten these four screws and measure the distance
between nozzle and presser again to check the inclination that the station has been
given.
5.1.4 Replacing heating resistances:
Once the tray has been withdrawn, to remove the pot first unplug and take out the
thermostat probe, then simply lift until it comes out from the pot swing pin.
GLUE POT M5: From outside it is easier to access the fixing cover for the bottom
and front heating resistances (Nº19,22). Having extracted these and the cable through
plate (nº42), there is full access to the resistances, which are protected by an asbestos
sheet (Nº20,23).
RESISTANCE Nº RESISTANCE VALUE
32 600 W
33 500 W
34 250 W
Fixing
screw