Robland KM 775, Instruction Manual

Page: 19 / 70

Instructions manual KM 775 - 785
12
5 WORKING STATIONS:
5.1 Glue pot station:
This consists of a roller to glue the band. It must trace 2mm on the board and with
no type of extra regulation must dispense the exact amount of glue on the different sizes
of board, in terms of both width and height.
5.1.1 Dispensing glue:
The thickness of glue on the dispensing roller is regulated by the regulator finger
on the glue flap.

TURNING CLOCKWISE REDUCES THE AMOUNT OF GLUE.

TURNING ANTI-CLOCKWISE INCREASES THE AMOUNT OF GLUE.

5.1.2 Glue level in the tank:
For correct operation, the level must not cover the access door to the inner tank,
because if this happens the gases produced will only be able to escape through the glue
nozzle, and this may cause irregularities in the amount of glue supplied to the edge. On
the other hand, with a very low level the glue would burn, losing its properties and even
forming a layer of encrusted glue that would insulate the glue from the heating
resistances in good conditions, leading to an increase in heating time.
Max. Glue level
Glue flap regulator
Clockwise supplies less glue
Anticlockwise supplies more glue
Securing nut
Thermostat probe casing