Robland KM 775, Instruction Manual

Page: 25 / 70

Instructions manual KM 775 - 785
18
5.3.4 Working limits:
The minimum distance between boards must be respected. This is shown on the
sticker on the side of the machine: when the back of the board reaches this sticker, the
next board can be introduced.
5.3.5 Mechanical regulation:
After pneumatic regulation, to make the cut attention must be given to the tracers.
If front trimming has to be adjusted, it is tracer nº 1 that has to be moved; first slacken
the tracer fixing screws, then turn the regulating knob in direction clockwise for the
tracer to move in, so that the disc will cut more, or alternatively in direction anticlockwise
to move the tracer out and cut less. If adjusting the back cut, the fixing screws on tracer
nº 2 must be slackened in orde
r to turn the regulating knob “clockwise” for the tracer to
move in and cut more, or in direction
“anti-clockwise” for the tracer to move in and cut
less.
The fixing screws must always be firmly tightened after adjusting either of the two
tracers. Also, never loosen the four fixing screws at the same time; first adjust one tracer,
then the other one.
5.3.6 Replacing the end trimmer discs:
First make completely sure that the machine is totally at rest and turned off at the
main switch. Then lock the motor with the key supplied, and remove the fixing screw to
free the bush and disc. After changing discs, always check that the fixing screws are
firmly tightened.
Tracer fixing screw Rear Tracer
nº2
Fixing screw
Front Tracer
nº1 Regulating
knob