Roberts Gorden Combat MGB0100, Installation Manual

Page: 60 / 92

COMBAT
®
C
ABINET
H
EATERS
I
NSTALLATION
, C
OMMISSIONING
, O
PERATION AND
S
ERVICE
M
ANUAL
54 of 85
Direct-Spark I g niter Replace if there are cracked ceramics, excessi v e carbon resid u e, or erosion
of the electrode.
See b u rner man u fact u rer’s instr u ctions.
Thermostat There sho u ld be no exposed w ire or damage to the de v ice or w iring.
See Page 27, Section 9
.
Support Points Make s u re the heater is properly s u pported.
Make s u re the heater is placed on a firm, le v el, non-comb u stible s u rface that
can s u pport its w eight. See Page 8, Section 4.1 .
Silicone Tubin g Ens u re tight, sec u re fit on all press u re fittings at press u re s w itch,
b u rner partition, and blo w er o u tlet.
Gas Valve Verify that cap co v ering press u re reg u lator adj u stment scre w is sec u re and
has not been tampered w ith.
Verify all w iring connections.
Condensate Drain
(when installed) Fl u sh drain and clear any obstr u ctions.
Ductwork Cons u lt an indoor air q u ality professional for proper cleaning proced u res
Air Circulation Blower For a complete inspection, refer the man u fact u rers Installation, Operation and
Ser v ice man u al.
Wall Plate If w all plate is present, make s u re it is legible and acc u rate. Please contact
Roberts-Gordon E u rope Limited if yo u need a w all tag. See Page 4, Section
2.1 .
Safety Labels Prod u ct safety signs or labels sho u ld be replaced by the prod u ct u ser w hen
they are no longer legible. Please contact Roberts-Gordon E u rope Limited or
yo u r ROBERTS GORDON ® independent distrib u tor to obtain replacement
signs or labels. See Page 3, Figure 1 .