robert juliat
Route de Beaumont F 60530 Fresnoy-en-Thelle phone: 33 (0)3.44.26.51.89 - fax: 33 (0)3.44.26.90.79 - www.robertjuliat.fr
Robert Juliat r
eserve the right to change or alter any of the items detailed on this page, to incr
ease or impr
ove manufacturing
techniques without prior notice.
VALID SINCE
: 16.02.05
DocT
ech1011_BC_0205.ind
6
TECHNICAL FILE
1200W HMI FOLLOW SPOT
DISCHARGE LAMP LUMINAIRES
USER’S INSTRUCTIONS
(
*
) Only for profi le spotlights.
Read user’s instructions before using this lighting unit.
Besides these instructions indicated on this page, you must respect the relevant safety and health
related requirements of the appropriate EU Directives.
This unit enters section 17: Lighting appliance for theatre stages, television, cinema and photograph
studios. Standards applied: EN 60598-1 and EN 60598-2-17.
This unit is considered as IP20, reserved for indoor use only.
LIGHTING UNIT.
Disconnect from the mains before any servicing.
Warning :
high voltage ignition.
The protection screens, lenses or U.V.
fi
lters must be replaced if there is any visual damage to a point
where their performances are reduced, for example, by cracks or deep scratches.
The lamp must be replaced if damaged or deformed by the heat.
Do not use a bulb with a power or type which is different to that indicated.
Make sure the unit is correctly mounted on an appropriate support.
In a hanging position (hook, bolt...), the safety requirement of the unit must be secured with a hanging
accessory (security cable, chain...) with a suitable length and correctly attached at the back of the
unit. This must be mounted as short as possible or rolled up a few times if needed.
Their movable accessories (barndoors, HMI shutters...) must also be secured with a suitable security
cable hooked onto the front of the unit. Take into account the weight, for a correct attachment of the
security cable.
Do not open the lighting unit, when the lamp is on.
U.V. rays: Protect your eyes.
Bulb and holder hot: wait until the unit is cold, before servicing.
Do not tamper with the security layout.
Tighten regularly the connections. Replace the cable with an identical one, if damaged.
Check the distance from any
fl
ammable material.
Do not expose to bad weather. Do not cover.
Use only with correct power supply.
Use only when lamp is in place.
If the lighting unit has any fans, make sure they are working correctly. If any are not working, turn the
unit off immediately and carry out the necessary servicing.
Clean frequently the
fi
lters, if any.
Do not obstruct the air gaps.
Keep optical parts clean.
POWER SUPPLY.
Disconnect from the mains before any servicing
Mains connection only, do not connect to an "electronic output" (dimmer, static relay...).
Shelter from bad weather - in an air-cooled area - do not cover.
The power supply has circuit breakers, which should always be kept accessible.
There is no maximum distance between the lighting unit and the power supply, if you take in conside-
ration the section of the cable used.
Check the mains voltage.
These products have been built in conformity with European standards related to professional lighting
equipment. Any modi
fi
cation made to our products will cancel the manufacturer’s responsibility.
Professional material : Service only by qualifi ed technician.
Thank you for your attention.
•
•
•
•
•
*
*
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Summary of Contents for 1011+
Page 2: ...NOTES ...
