robert juliat
Route de Beaumont F 60530 Fresnoy-en-Thelle phone: 33 (0)3.44.26.51.89 - fax: 33 (0)3.44.26.90.79 - www.robertjuliat.fr
Robert Juliat r
eserve the right to change or alter any of the items detailed on this page, to incr
ease or impr
ove manufacturing
techniques without prior notice.
VALID SINCE
: 16.02.05
DocT
ech1011_BC_0205.ind
16
TECHNICAL FILE
1200W HMI FOLLOW SPOT
ADMISSIBLE LAMPS :-
OSRAM: HMI 1200W/GS
PHILIPS: MSI 1200
Manufacturer's recommendations:
• Read attentively the manufacturer's instructions.
• Positioning of the lamp and connecting of the power supply require great care. To make sure there is a good
conduction of current, the mechanical support and the electrical connections must be free form dirt and corrosion.
The clamps and brackets must be checked whenever the lighting unit has been transported.
• The lamp emits ultraviolet radiation. Direct exposure can be harmful to your health.
• It is recommended to avoid air draughts, also avoid exposing the lighting unit to bad weather.
• Use only when bulb in place
Technical characteristics:
User's precautions:
• The lamplife, as given by the manufacturer, is an theoretic lamplife duration as "in laboratory conditions" a cycle
based on 3 hours on / 1 hour off, cycles more brief, reduce the duration of the lamplife.
• In operating conditions it is uncommon for the lamp to be still working after 200 to 300 hours. Its efficiency can
decrease 30%.
• Premature wearing of lamp under performing conditions, is mainly due to frequent switching on. Better to leave
the lamp on, through the performance, rather than switching it on repeatedly. ( The lamplife is reduced about
1 hour, each time the lamp is lighten ). It is advised to wait for 10 minutes before switching on again.
(This extends the duration of the lamp.)
•
Use over 500 hours of the lamp : change the lamp even thou it still lights up.
New lamp:
• To achieve a good ionization of a new lamp, when using it for the first time, it is recommended to leave it on
for a few hours.
• Preserve carefully the guarantee slip of the lamp, as it may be asked for in the event of a dispute.
Thank you.
1011+, 1011+B &
1011+C
Nominal absorbed voltage ......................................................................1200 Watts ............1200 Watts
Voltage use: .............................................. (European standard) 230/245 Volts 50Hz ..............................
Voltage use: ............................................(North American standard) 208 Volts 60Hz ....... 110Volts 60Hz
Minimum voltage of the power supply .......................................................198 Volts .............. 198 Volts
(Below this charge = possible ignition failure).
Voltage at the terminals of the lamp ...........................................................100 Volts ............... 100 Volts
Amperage at the terminals of the lamp ................................................... 13,8 Amps .............13,8 Amps
Luminosity of the lamp ........................................................................... 110 000 L's ........... 110 000 L's
Luminous effectiveness .............................................................................. 92 Lm/W ............... 92 Lm/W
Colour temperature ................................................................................ 5600 Kelvin ........... 5600 Kelvin
Base ........................................................................................................ SFa 15,5-6 ............ SFa 15,5-6
Manufacturer’s rated life ............................................................................750 hours ............. 750 hours
HMI 1200
- 1011+ & 1011+B 1011+C
Summary of Contents for 1011+
Page 2: ...NOTES ...
