4
as this can result in fire or electric shock.
Do not allow anything to rest on the power cord. Do not locate this fixture where the cord may be damaged by
persons walking on it.
Make sure that the power cord is never crimped or damaged by sharp edges. Check the fixture and the power
cord from time to time.
Refer servicing to qualified service personnel.
Do not look at the fixture´s LEDs during operation. The light beam may damage your eyes.
This fixture falls under protection class I. Therefore this fixture has to be connected to
a mains socket outlet with a protective earthing connection.
Do not connect this fixture to a dimmer pack.
To guard against epileptic seizure:
Do not operate the fixture near stairways. Provide advance notice that strobe lighting
is in use. Avoid extended periods of continuous flashing, particularly at frequencies of
10 to 20 flashes per second
If the fixture has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on
immediately. The arising condensation water might damage your device. Leave the device switched off until
it has reached room temperature.
When choosing the installation spot, please make sure that the fixture is not exposed to extreme heat, moisture
or dust.
Air vents and slots in the fixture are provided for ventilation, to ensure reliable operation of the device and to
protect it from overheating.The openings should never be covered with cloth or other materials, and never
must be blocked.
This fixture should not be placed in a built-in installation unless proper ventilation is provided.
Never place filters or other materials over the front glass cover.
Only operate the fixture after having checked that the housing is firmly closed and all screws are tightly fastened.
To avoid damage of the internal optical system of the fixture, never let the sunlight (or other
light source) lights directly to the lens array, even when the fixture is not working !
Keep flammable materials well away from the fixture.
Provide a minimum clearance of 0.3 meters around air vents
Always use a secondary safety cable when rigging this fixture.
Make sure that the area below the installation place is blocked when rigging, derigging or servicing the fixture.
The fixture becomes very hot during operation. Allow the fixture to cool approximately 20 minutes prior to ma
-
nipulate with it.
Operate the fixture only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the fixture. Most damages are the result of unprofessional operation!
Please use the original packaging if the fixture is to be transported.
Please consider that unauthorized modifications on the fixture are forbidden due to safety reasons!
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like
short-circuit, burns, electric shock, crash etc.
