12
Multiply fixtures installation via floor stand
Maximum 6 fixtures can be connected in the top-to-bottom method
Always use a floor stand for multiply fixture installation in the top-to-bottom method on the floor.
To install multiple fixtures
in the top-to-bottom method on the floor stand
1.
Move both levers (23) to unlock position (red mark is visible) on the floor stand (21).
2.
Put the first fixture with its feet
(8) into the slots (22) in the floor stand (21)
and move the fixture in
a direction as show red arrows on the picture below until you feel a stop.
3.
Secure the fixture in the floor stand by means of its locking mechanism: move both levers (23)
to the position until the green mark is fully visible.
4.
Put the second fixture with its feet (8)
into the slots (14) in the first fixture
and move the fixture in
a direction as show red arrows on the picture below until you feel a stop.
5.
Secure the first fixture with the second one by means of its locking mechanism: move both levers (18)
to the top position until the green mark (17) is visible and move the plastic levers (19) into position under
locking levers (18) until they snap. Now levers (18) cannot be moved to unlock position.
6.
Make the secondary securing of this fixture. Loosen both tilt locks (9) and move the U-holder (13)
to the horizontal position. Loosen the nuts (12) and move the segments (11) towards the nuts (10).
Loosen the nuts (10) and fasten the parts (11) under them. Tighten the nuts (10) and the tilt locks (9).
7.
Repeat steps 4-6 for next fixture. In this way, up to six fixtures can be connected each other.
8.
Check, that all nuts (10) and tilt locks (9) are fully tightened.
Always check that locking mechanisms are locked before connecting next fixture!
.
