24
S1-1 - a strobe lamella 1 position 1
S1-2 - a strobe lamella 1 position 2
S2-1 - a strobe lamella 2 position 1
S2-2 - a strobe lamella 2 position 2
Store - saving adjusted values
Cal Load
- Loads default (factory) calibration.
Calibration of the pan/tilt via the control board
1. Disconnect DMX controller from the fixture and enter the "Cal P/T" menu.
2. Use the [PREV] and [NEXT] to find "Pan" and press [ENTER].
3. Set desired value and save it by pressing [ENTER].
4. Repeat steps 2 and 3 for Tilt.
5. After calibrating both effects, find item "Store" and press [ENTER] to save all adjusted values and reset the
fixture.
Calibration of effects via the control board
1. Disconnect DMX controller from the fixture and enter the "Cal Eff" menu.
2. Use the [PREV] and [NEXT] to find desired effect and press [ENTER].
3. Set value and save it by pressing [ENTER].
4. Repeat steps 2 and 3 for another effect.
5. After calibrating desired effects, find item "Store" and press [ENTER] to save all adjusted values and reset
the fixture.
Note: you can also use DMX controler for both calibrations stated above, calibration protocol is the following:
Effect
Mode 1
Mode 2
Mode 3
Pan
channel
23
channel
17
channel
28
Tilt
channel 24
channel 18
channel 29
Colour wheel
channel 25
channel 19
channel 30
Static Gobo
channel 26
channel 20
channel 31
Prism 14.6°
channel 27
channel 21
channel 32
Prism 14.6° Rotation channel 28
channel 22
channel 33
Prism 16°
channel 29
channel 23
channel 34
Prism 16° Rotation
channel 30
channel 24
channel 35
Focus
channel 31
channel 25
channel 36
Frost position 1
channel 32
channel 26
channel 37
Frost position 2
channel 33
channel 27
channel 38
Strobe lamella 1 pos. 1 channel 34
channel 28
channel 39
Strobe lamella 1 pos. 2 channel 35
channel 29
channel 40
Strobe lamella 2 pos. 1 channel 36
channel 30
channel 41
Strobe lamella 2 pos. 2 channel 37
channel 31
channel 42
Sw Upd
-
The menu item allows you to update software in the fixture via the Robe Universal Interface.
The following are required in order to update software:
- PC running Windows 95/98/2000/XP/7/8 or Linux
- Software Uploader
- Robe Universal Interface or Flash cable RS232/DMX (S.N.13050624)
Note: Software update should execute a qualified person. If you lack qualification, do not attempt the update
yourself and ask for help your ROBE distributor.
DMX address, programs 1-3 and all items in the menu "Personality" will be set to their default (factory) values.
To update software in the fixture:
I. Installation of the Robin miniPointe Software Uploader.
1. The Robin miniPointe Software Uploader program is available from the ROBE web site
at WWW.robe.cz.
2. Make a new directory ( e.g. Robe_Uploader) on your hard disk and download the software to it.
3. Unpack the Software Uploader.
II.Fixture software updating.
1. Connect DMX output of the Robe Universal Interface with the fixture. Connect USB input of
the Robe Universal Interface with your PC (or, if you use the Flash cable, use it to connect serial
port of your PC with the DMX input of the fixture)
