Robin CycBar 15
5
3. Installation
3.1 Rigging the fixture
The Robin CycBar 15 can be rigged in any orientation on a truss without altering its operation characteristics.
For overhead use, always install a safety cable that can hold at least 10 times the weight of the fixture. You must
only use safety cable with screw-on carbine. Use the safety wire anchor point for safety cable attachment for this
fixture.
Ensure that the structure (truss) to which you are attaching
the fixture is secure
Fixture may cause severe injuries when crashing down! If you have doubts concerning the safety of a possible
installation, do not install the device and consult installation with an expert.
Truss installation
1. Bolt clamps (1) to the omega holders (2) with M12 bolt and lock nut through the hole in the omega holder.
2. Fasten the omega holders to the brackets of the CycBar 15 by inserting both ¼ turn quick locks (3) into
the holes of the brackets and tighten fully clockwise.
3. Clamp the fixture on a truss (5) and tighten both rigging clamps.
4. Pull a safety wire (4) around the truss (5) and lock the screw-on carabine through attachment point (6) as shown
on the picture below.
For overhead installation, the fixture must be always secured with a safety wire that can
bear at least 10 times the weight of the fixture
1- Clamp
4- safety wire
2- Omega holder
5- truss
3- ¼ turn quick locks 6- attachment point
