DigitalSpot 5000 DT
7
Rear panel of the fixture base
5. Video inputs
Both
VGA
(8) and
S-Video
(9) inputs provide direct connection to the projector. The inputs are intended for a static
presentation as data going through the inputs cannot be processed in a graphics engine ,it means that graphics
effects from a DMX protocol will not be usable. In this use of the fixture, the function of Keystoning from a DMX
protocol will not operate. Next both inputs
S-Video
(13) and
Composite
(14) enable to process data in a graphics
engine, it is means that you can use all spectrum of effects that the DMX protocol offers.
6. Connection to the mains
Install a suitable plug on the power cord, note that the cores in the power cord are colored according to the
following table.
Core (Eu)
Core (US)
Pin
Symbol
Brown
Black
Live
L
Light blue
White
Neutral
N
Yellow/Green
Green
Earth
The earth has to be connected!
6.1 Powering on the DigitalSpot 5000 DT
When the fixture is connected to the AC mains supply and the power switch is on, it automatically begins a homing
procedure to verify that all functions of the fixture and its internal projector are in good order.
6.2 “Power down” mode
This mode omits fixture reset after switching the fixture on and deactivates all motors. The "Power down mode" is
useful in special events e. g. if the fixture is placed in a flight case and you want to set its DMX address without
taking it out from the case.To enter the "Power down mode",press and hold the [ENTER] button and at the same
time switch on the Power switch. Press the [ESC] button to see a notice "Power Down Mode."
Now you can use the fixture menu to set desired behaviour of the unit. If you want to go to the standard
operation mode without switching the fixture off, run total reset of the fixture (menu item
Reset all Systems
).
1
- Power cord
2
- Power switch
3
- Fuse
4
- 5-pin DMX outputt
5
- 5-pin DMX input
6
- Ethernet input
7
- USB inputs
8
- VGA intput-dataprojector.
9
- S-video intput-dataprojector
10
- 3-pin DMX input
11
- 3-pin DMX output
12
- ATX switch
13
- S-video input- graphics engine
14
-Composite input-
graphics engine