DigitalSpot 5000 DT
22
Display Adjusting
--- This function allows you to change the display settings:
Display Permanent On
- This function allows you to keep the display permanent on or
to turn it off after 5 minutes of inactivity of control buttons (wheel)
Display Orientation
- Select this function to adjust the display orientation:
Normal orientation
- A standard display orientation.
Rotated Orientation
- Inverts the display by 180°.
Pan/Tilt Feedback
--- This function allows to return the moving head to the required pan/tilt position after
changing the position by an external force (e.g. by a stroke).
Be careful, the Pan/Tilt Feedback OFF is not the standard operation and the head of the fixture can be damaged!
Note: If the feedback was switched off ,the pan/tilt position is changed by an external force and the feedback is
switched on again, the moving head might not to be synchronized with the DMX signal. You have to make a reset in
order to synchronize the moving head with the DMX signal.
Pan/Tilt mode
--- Use this menu to set the character of the pan/tilt movement.
Time mode
--- Pan and tilt will move with different speeds and they will come at the same
time to the end point (pan and tilt sets its optimal speed).
Speed Mode
--- Pan and tilt will move with the same speed as adjusted by the channel 5.
(Pan/Tilt speed). E.g. pan will come to the end point and wait for tilt, which has longer track.
Active Blackout while:
--- Use this function if you wish to close the light output during the following events:
During Movement correction
--- Select this function to enable the blackout during the head
movement correction (if the moving head lost its right pan/tilt position for a short moment).
Pan/Tilt Moving
--- This function closes the light output during pan/tilt changing.
Projection Presetting
--- Use this menu depending on the installation location of the fixture:
Ceiling Projection
--- When this function is "On", a picture is top (bottom and left) right
reversed.This function enables to project the image from a ceiling mounting of
the DigitalSpot 5000 DT.
Rear projection
--- When this function is "On", picture is left (right) reversed.
This function enables to project the image to a rear projection screen.
DMX protocol
--- Use this menu to to select a desired protocol version.
Protocol Version
:
Version 3.9
--- contains 86 control channels.
Version 4.7
--- contains 87 control channels.
Version 5.5
--- contains 95 control channels.
Versions 6.3
--- contain 103 control channels.
Gobo Selection Mode
--- Use this menu to select desired sorting of media files in media subfolders.
Alphabetical Order
--- The media files are assigned to DMX values in an alphabetical order.
Numerical projection
--- The media files are assigned to DMX values in a numerical order.
Verbose Mode
--- Use this menu to hide messages displayed on the screen when you are changing some setting
on the
Power/Special functions
channel (e.g. Rear projection on, Rear projection off.....) .
Verbose Mode 0
--- Generated messages are hidden.
Verbose Mode I
--- Generated messages are visible on the projection screen.
DMX Verbose Mode
--- It displayes information regards picture at the bottom left corner of
the image (channel, name, DMX value):
