6
Gas Hob
Locating rod
Locating hole
Operation Methods
1.Check if the cooper core, cooper cap, pot rack, etc. are in place. Confirm the location of the switch
knob (See Fig. 1) and then open the valve of gas source.
2.Ignition: Press and hold the switch knob and rotate it for 90 degrees counterclockwise for high flame
(See Fig. 2). At this time, a continuous “clicking” sound of pulse ignition can be heard. After ignition, do
press and hold the switch knob for 3~5 seconds (to the maximum extend) before releasing. If flame is
observed, the product can be used safely. If no flame is observed, please repeat the above operations.
The switch knob can be rotated for another 90 degrees counterclockwise for low flame (See Fig. 3).
picture2
picture1
picture3
Notes: When a stove is used for the first time or resumed after a long time, the first attempt of
ignition may fail due to the residual air in the hose. Therefore, repeat operations are required.
3 . F l a m e - o u t : R o t a t e t h e s w i t c h k n o b c l o c k w i s e t o t h e ( F i g . 1 ) l o c a t i o n f o r f l a m e - o u t .
4.Flame adjustment: Rotate the switch knob according to its flame indication to obtain the
flame.
5.Air adjustment: In order to realize the optimal combustion status of flame, air adjustment can be
carried out at air inlet. Rotate the throttle (at the bottom of stove) clockwise or counterclockwise till the
flame becomes clear, stable and blue in color (See the figures below). Different combustion statuses
can be discriminated as follows:
corresponding
Good combustion : The flame is blue in color with distinct inner and outer flames. No yellowish or
reddish flame is observed.
Insufficient air : The flame elongates and is in yellowish or reddish color with no distinct (blurred)
inner and outer flames.
Excessive air : The flame is cyan in color and lifted, i.e., away from the cooper cap and cooper core,
or shortens distinctly (flareback may occur in case of manufactured gas).
Normal
(complete combustion)
Yellow flame
(insuficcient air)
Lifted flame
(excessive air)
Air inlet
Throttle
Throttle
Switch
Pan
Stand
Copper
Core
Copper
Cover
Aluminum Base
Electrode
Needle
Thermocouple
Burner
water pan
图
1
图
2
图
3