Gas leakage
(odor of gas)
Abnormal
combustion
or noises
Close the switch knob
Connect the hose properly or replace it
The switch knob is not closed
The hose is not proper connected
or has cracks
Faults
Ignition failure
Flame extinct
after releasing
Solutions
Close the switch knob of stove and then open
the valve of gas source
Carry out ignition repeatedly to exhaust the air
in pipe
Straighten, unblock or replace the hose
Clean the head
Adjust the distance between the ignition
electrode and the receiving end at around
4 mm
The cooper core and cooper cap must be put
in place
Narrow down the throttle
After ignition, hold and press the switch knob
for 3~5 seconds (to the maximum extend) and
then release it
Causes
The cooper core and cooper cap are
not in place
The knob is not pressed to the
maximum extend
Bending, blocking or pressing of hose
Air in gas pipe
The switch of gas source closes
The porcelain head of ignition electrode
is not clean
Improper distance between the ignition
electrode and the receiving end
The throttle is so wide that causes lifted
flame
1.
Instruction book
2.Installation templet
3.One battery
4.Clamps 2 (excluding the products with metal hose)
Accessories
8
Gas Hob
Common Faults and Solutions
No battery, wrong battery installation or
insufficient electric power
Correct install the battery or replace it with a
new one
Improper adjustment of throttle
Blockage of burner or flame outlet
The gas used is not in consistence
with the gas type marked on stove
Unstable gas pressure, water in hose
Adjust the throttle
Remove the blockage
Select correct stove
Remove the water in hose
Switch
Pan
Stand
Copper
Core
Copper
Cover
Aluminum Base
Electrode
Needle
Thermocouple
Burner
water pan
图
1
图
2
图
3
