RMG TME400-VM, Operating Manual

Page: 24 / 137

1 Introduction
Manual TME400-VMF · EN07 · December, 7
th
2020
18
The EC type approval certificate is:
TÜV 17 ATEX 207566 X
IECEx TUN 18.0009 X
The corresponding conformity certificates are provided in the annex. The RMG con-
tact information is provided on the second and last page.
1.3.4.1. Installation and mounting position
The TME400-VM and TME400-VMF can be supplied with DIN and ANSI connec-
tions. Up to nominal diameter DN 200, the installation position of the turbine meter
with permanent lubrication can be selected as required. From nominal diameter
DN 250, the meter must be installed in the ordered installation position. It must also
be ensured that the filling opening of the lubrication faces upwards.
1.3.4.2.
Temperature ranges
The turbine meter TME400 in standard version is approved for the following tempera-
ture ranges.
Temperature ranges
Medium temperature -25°C to +55°C
According to ATEX (T
amb
)
-25°C to +55°C (II 2G Ex ia IIC T4)
According to PED 2014/68/EU -20°C to +80°C (spheroidal graphite iron)
-40°C to +80°C (cast steel)
-40°C to +80°C (stainless steel)
-10°C to +80°C (welded version
and round steel material)
Pressure safety for DN25 according
to sound engineering practice, see
PED 2014/68/EU, sec. 4, subsec. 3 -40°C to +60°C (aluminum)
Lower temperature limits are available on request with the welded version and round steel material.
Caution
Direct solar radiation must be avoided.