RMG TME400-VM, Operating Manual

Page: 109 / 137

APPENDIX
Manual TME400-VMF · EN07 · December, 7
th
2020
103
103
F Later installation of the power module
Caution
The power module must only be installed in a de-energized state.
In order to switch of any power supply the battery must be removed (see
chapter
3.1.4 Battery replacement ) and any external supply voltage must be switched off,
i.e. in the case of an external supply, the wires from terminals X6 / +Uext and X6 /
-Uext must be removed.
The power module
(3) must be plugged on as shown in Figure 19: Electronic with
power module . The current module is factory adjusted and does not need to be
calibrated before operation.
Figure 19: Electronic with power module
1
Jumper for RS 485 terminating resistor. Bridged: with 120
W
; open:
ꝏ W
2 Calibration switch
3 Current module board