RMG TERZ 94, Operating Instructions Manual

Page: 27 / 66

Operation
Operating Instructions for the TERZ 94 Electronic Turbine Meter
25
NOTE:
The button located externally on the case reacts when it is released and not
when it is pressed. The duration of pressing the button is evaluated and
results in different reactions of the device.
Pressing the button for a short time causes the display to show the next
display value, while pressing the button for a longer time (more than 2
seconds) will activate all segments of the display (segment test) and then the
display will switch over to showing the Vm totalizer.
The following text describes procedures where the button is normally pressed
for a short time.
Programming
For programming the TERZ 94 / 94-S, there are four buttons on the rear side
of the board. Alternatively, you can program the device with the programming
module (available as an accessory). The programming module is to be
connected to the pin connector indicated in the picture below.
P
+
-
|
→
Programming
module