Safety reliably produced.
© RLS Wacon analytics GmbH ∙ +49 (0)5121 28126 0 ∙
Subject to
change without notice
11
Performance features
Diagnostic programme (LIMESPlus)
If technical problems occur at the unit, a fault message is output by
switching a potential-free relay. The detailed diagnostic programme
in
LIMESPlus
enables step-by-step testing of all unit functions. In
this way, the unit is thoroughly checked, and the cause of the error
message is clearly identified.
Minimal maintenance effort
Depending on the set measuring interval or the frequency of the
measurements, the measuring chamber must be cleaned. The hose
pump cassette and sealing rings typically only need to be replaced
every 24 months.
Efficient reagent consumption
The reagent bottle is easy to replace. A freshly inserted 750 ml
bottle allows up to 10,000 analyses.
Digital input contact (INPUT, start or stop analysis interval) only with LIMESPlus
The potential-free switch of a flow monitor, a timer or another
status switch can be connected to this input, for example. When
the contact is open, no analyses are carried out in the programmed
interval.
Alternatively, this input can be used as a start input for analyses.
Two potential-free relay outputs
The potential-free relay outputs can be used to signal a limit value
alarm, a device fault or a reagent message BoB, e.g., to a control
room. Alternatively, signalling devices or service valves can be
switched.
Summary of Contents for 32-074165
Page 76: ......
