Gas Tracer Operator’s Manual, CSA Version
Standard Accessories • 19
Standard Accessories
The standard accessories include the tapered rubber nozzle, belt clip, sample
hose, and 10 inch probe. An optional bar hole probe is also available and is
described at the end of this section.
Tapered Rubber Nozzle
A cone shaped 4 inch long rubber nozzle is included with the Gas Tracer as
standard. It can be installed on the inlet fitting by pushing the larger end over it.
The smaller end can be inserted through a hole in a wall or some other access to
an enclosed area to sample the environment.
Belt Clip
A belt clip can be mounted to the back of the case using 3 Phillips head screws.
The belt clip allows the Gas Tracer to be securely attached to a belt.
Wrist Strap
A wrist strap is included with the Gas Tracer and can be attached to the right or
left wrist strap installation feature.
Sample Hose & 10 Inch Probe
A 10 foot sample hose and a 10 inch probe are included as standard with the Gas
Tracer. When desired, the rubber nozzle may be removed and the sample hose
and 10 inch probe may be connected to the inlet fitting. Sample hose lengths are
available from 10 feet to 50 feet (see “Parts List” on page 173). The quick connect
end of the sample hose connects to the inlet fitting of the Gas Tracer and the probe
screws onto the end of the hose with the threaded fitting.
CAUTION:
Sample hose lengths of more than 50 feet are not recommended for the Gas
Tracer because of flow rate reduction.
Figure 4: Sample Hose and Probe
Sample Hose
Probe
