23 • Connecting Multiple SDM-6000s Together
18. Click
Finish
once the drivers are successfully installed.
Figure 16: Finish Device Driver Installation
The installation will continue.
19. Follow the on-screen instructions to complete software installation.
20. To complete the driver installation, ensure that your docking station (or the
master docking station if you plan to have a bank of them) are connected to
your computer.
21. Turn on the docking station by flipping the power switch to the ON position.
22. The first time an SDM-6000 is turned on after being connected to the
computer, the SDM-6000 needs some time to be recognized by the computer.
The status bar will indicate that the drivers are being configured and will alert
you when the SDM-6000 is ready to use.
Connecting Multiple SDM-6000s Together
Up to 10 SDM-6000s can be connected together. The leftmost SDM-6000 is the
master station and the remaining stations are slave stations. If you remove the
leftmost SDM-6000 from the setup, the station that is now the leftmost station
becomes the master but does not retain any of the settings that the old master had.
1 . Be sure that the SDM-6000s are not connected to power.
2 . For every station except the one that will be located on the far right side of the
bank:
a. Unscrew the two screws that retain the panel on the right side of the
station. The screws are not captive. Be sure not to lose them.
b. Pull the panel away from the SDM-6000.
