AirLink 9850 Gas Monitor Operator’s Manual
Chapter 3: Installation • 15
6. For versions that did not come with a pre-wired AC line cord:
•
Connect a line wire from the AC power source to the power supply’s “L” terminal.
•
Connect a neutral wire from the AC power source to the power supply’s “N” terminal.
•
Connect a ground wire from the AC power source to the power supply’s “EG” terminal.
NOTE:
If the AirLink 9850 was not ordered with any housing holes, at least one hole will have to be
drilled to bring in AC power.
Figure 6: AC Wiring
7. Close the Front Panel.
8. Screw in the thumb-screws.
9. Close the enclosure box.
10. Clamp down the enclosure latches.
