5. RKC COMMUNICATION PROTOCOL
IMR01J08-E1
22
5.3 Communication Identifier List
Communication is not possible when an identifier is specified that the controller can not
recognize.
The number of digits for data is 6.
Normal setting data
(Attribute
RO: Read only, R/W: Read and Write)
Name Iden-
tifier
Data range
Factory set
value
Attribute
Model code
ID
Display the model code
-----
RO
Measured value (PV)
M1
Within input range
-----
RO
Limit action monitor
OZ
0: Normal
1: Limit output ON
2: EXCD status
0 RO
Burnout
B1
0: OFF
1: ON
----- RO
Alarm 1 status
AA
0: OFF
-----
RO
Alarm 2 status
AB
1: ON
-----
RO
Peak hold value
monitor
HP
Setting limiter [low] to
Setting limiter [high]
----- RO
Bottom hold value
monitor
HQ
Setting limiter [low] to
Setting limiter [high]
----- RO
EXCD time
TH
0.00 to 999.59
(0 min 00 sec to 999 min 59 sec)
----- RO
Limit action release
HR
Transfer of limit action release signal
“0” setting:
0: Limit action release (always “1”)
“1” setting:
1: Limit action release (always “0”)
1 R/W
Alarm interlock
release
IR
0: Interlock release (always “1”)
1
R/W
1
Set value (SV)
S1
Setting limiter [low] to
Setting limiter [high]
0 (0.0)
R/W
Alarm 1 set value
A1
Process alarm, SV alarm:
Same as input range
Deviation alarm:
−
Span to +Span
However, within
−
1999 to +9999 digits
Temperature
input: 50 (50.0)
Voltage/current
inputs: 5.0
R/W
2
1
If Alarm 1, Alarm 2, Alarm 1 interlock, or Alarm 2 interlock are not provided, the attribute becomes
RO.
2
If Alarm 1 is not provided, the attribute becomes RO.
Continued on the next page.
