5 Configuring the automatic machine
12
We reserve the right to make technical modifications
Rittal crimping machine R8-I
EN
–
For every configuration
If you want to change to a different wire end ferrule type, you must first remove
any wire end ferrules still in the crimping unit. Proceed as follows:
◼
Remove the wire end ferrule reel.
◼
Continue to feed the deployed conductor into the automatic machine until only
the conductor is stripped of insulation.
All wire end ferrules have now been removed from inside the crimping unit.
The following settings must be checked, and modified when required, for every
configuration:
–
Wire end ferrule reel
–
Sleeve cross-section
Note:
The automatic machine must be switched off when configuring.
5.1
Inserting wire end ferrules
◼
Place the wire end ferrule reel (fig. 4, item 1) so that clockwise unrolling is possi-
ble.
◼
Turn the latch (fig. 4, item 2) on the front panel (fig. 4, item 3) so it opens.
Fig. 4:
Wire end ferrule reel
Legend
1
Wire end ferrule reel
2
Front panel latch
3
Front panel
1
2
3
