4 Transporting and installing the automatic machine
10
We reserve the right to make technical modifications
Rittal crimping machine R8-I
EN
Symbol
Meaning
Marked product must not be disposed of as house-
hold refuse. WEEE directive
Europe
4
Transporting and installing the automatic machine
4.1
Installation site
The installation site must satisfy the following requirements:
–
Stable base with flat, level surface (automatic machine weight, see section 3.1
"Technical specifications").
–
At least 30 cm free work surface on both sides and in front of the automatic ma-
chine.
–
Connection for electricity and compressed air easily accessible near the machine.
–
The ergonomic principles as standing or sitting workstation follow.
–
The workstation illumination should lie in the range 500
–
1000 lux.
Note:
The optimum operating pressure is 5.5 bar (±0.5 bar). Adequately
good crimping results cannot be achieved with less than 5 bar operat-
ing pressure.
Increased wear on the automatic machine can occur with more than
6 bar operating pressure.
4.2
Transporting an automatic machine
Caution!
◼
Always wear work shoes with foot protection when transporting
the automatic machine.
◼
Before transportation, always empty the waste container.
◼
Consider the weight of the automatic machine (see section 3.1). If necessary, use
a transport aid.
◼
Always use the side carrying handles to move the automatic machine.
◼
To prepare the automatic machine for shipping (e.g. for servicing), use the
transport packaging.
4.3
Unpacking the delivery
◼
Check the delivery for completeness (see section 4.4 "Scope of supply").
◼
Retain the transport packaging.
◼
Ensure that the operating instructions are always available for users.
4.4
Scope of supply
–
Insulation stripping and crimping machine
–
Mains connection cable (10 A, 250 V)
–
Compressed air hose
–
Allen key 2.5 mm
–
Operating instructions
–
Feeding funnel (3 sizes)
4.5
Installing connections
◼
Install the automatic machine at the envisaged location.
