RITE-HITE VBR-300 DOK-LOK Owner’s Manual
11
Install Signs
There are two (2) driver warning signs and one (1) inside
operator sign supplied with each
DOK-LOK
vehicle restraint.
Because of the many ways signs can be mounted, hardware is
not supplied. Mount both outside signs on the right hand side
of the
DOK-LOK
vehicle restraint. The mirror-image sign is
usually mounted above the lower sign and near the outside
signal lights. (Mirror-image permits the truck driver to read sign
from truck mirror.) Mount the inside sign next to the control box.
All signs must be installed.
NOTE 1
:
Figure 12
– Some docks may have dock/truck
seals (or shelters) installed or planned which are
larger than standard. Outside light, sign location,
and mounting should be studied before
proceeding to avoid interference.
NOTE 2
:
Figure 12
– If required for special reasons, signs
may be trimmed for fit. NEVER cut or eliminate
sign letters/words.
NOTE 3
:
Figure 12
– Attach signs with concrete anchors or
screws. Nails are not acceptable.
NOTE 4
:
Figure 12
– NEVER put conduit in front of signs. A
clear view of both exterior signs and the single
interior sign must be maintained at all times.
NOTE 5
:
Figure 12
– Secure R.I.G. sensor wire to wall.
Make sure wire is secured so barrier can travel the
full length of the track.
Operating Test
Follow
Operating Procedure, page 15
.
Figure 12
: Suggested Component Location
See NOTE 1
See NOTE 2
See NOTE 3
See NOTE 4
See NOTE 5
