PUB. NO. FASTRAXC FEBRUARY 2008
7
FASTRAX
™
MOTOR INSTALLATION
1.
Remove outer snap ring from drive shaft.
2.
Drive shaft is pre-lubricated at the factory, if more is
required, lubricate with an anti-seize lubricant.
3.
Slide gearbox housing onto shaft until it is against the rear
snap ring,
Figure 11.
4.
Rotate the drive tube until the key way slots are aligned
and install key.
5.
Install snap ring removed earlier.
6.
Tighten the rubber motor mounts on the back of the motor
mounting plate to reduce any motor rocking. Tighten the
rubber mount nuts to lock in place. After motor is
wired,run to verify motor does not rock.
7.
Remove the (2) screws from the motor junction box cover,
locate the electrical module and install onto the motor
junction box cover.
LIMIT SWITCH INSTALLATION
1.
Remove hinge pin from bracket on the gearbox,
Figure 11.
2.
Slide hinge pin thru limit switch assembly and gearbox
bracket.
3.
Install limit switch drive sprocket onto the drive shaft and
using a straight edge, align with the driven pulley on the
limit switch assembly. Sprocket DOES NOT require a key.
4.
Tilt limit switch assembly and install the chain over the
sprockets. The weight of the assembly as well as the
foam block will keep tension on the chain.
5.
Plug limit switch cables into the electrical module.
6.
Fasten chain from gearbox to bracket,
Figure 12.
MOTOR / LIMIT SWITCH INSTALLATION
FIGURE 11
Motor/Brake/Gearbox
Assembly
Drive Shaft
(After Installation, Apply
Grease for Ease of Removal)
Bumper Block - After Installed,
Loosen Nut, Tighten Against
Mounting Plate and Lock Nut
Make sure snap ring is fully seated in groove.
C A U T I O N ! ! !
!
Closed Limit Switch Magnet
(Red Dot)
Open Limit Switch Magnet
(Blue Dot)
Closed Limit Switch
(Red Dot)
Open Limit Switch
(Blue Dot)
Lower Photoeye
Cut-Off Switch
Upper Photoeye
Cut-Off Switch
Alternate Open
Limit Switch
Limit Switch
Assembly
Limit Switch
Hinge Pin
Gearbox Key
Outer Gearbox
Snap Ring
Limit Switch
Drive
Sprocket, No
Key Required
Limit Switch Chain
Conduit Bracket
Limit Switch Bracket
Electrical Module
FIGURE 12
Alternate
Cut-Off Switch
Inner Snap Ring
Foam Block
Chain
Connector
Chain
Motor J-Box Cover
To Raise Door w/o
Power, Turn Output Shaft
Summary of Contents for FASTRAX
