background image

when installing and using this electrical equipment, basic 

safety precautions should always be followed, including the 

following: 
1. REaD aND fOLLOW aLL INStRUCtIONS. 

2. WaRNING - to reduce the risk of injury, do not 

permit children to use this product unless they 

are closely supervised at all times. 
3

. in standard form, the riptide pool requires only one 

supply of 240 volts 32 amp or 45 amp. Please consult with 

a qualified electrician to verify current legislation 

aLWayS USE a QUaLIfIED ELECtRICIaN tO 

CONNECt thIS POOL tO yOUR ELECtRICIty 

SUPPLy 
4. DaNGER - risk of accidental drowning.

 extreme 

caution must be exercised to prevent unauthorised access 

by children. to avoid accidents, ensure that children cannot 

use the riptide pool unless they are supervised at all times. 

5. DaNGER - risk of injury. 

the suction fittings in 

the riptide pool are sized to match the specific water flow 

created by the pump. should the need arise to replace the 

suction fittings or the pump, be sure that the flow rates are 

compatible. never operate the riptide pool if the suction 

fittings are broken or missing. never replace a suction fitting 

with one rated lower than the flow rate marked on the original 

suction fitting. 

6. DaNGER - risk of electric shock.

 Do not permit 

any electrical appliance, such as a light, telephone, radio, 

or television, within 5 feet (1.5m) of the unit. these units 

have an integral ground fault circuit interrupter, but this only 

covers the pools’ own electrics.

7. WaRNING - to reduce the risk of injury: 

a) Before entering the pool check the temperature. 
b) since excessive water temperatures have a high potential 

for causing foetal damage during the early months of 

pregnancy, pregnant or possibly pregnant women should 

seek advice before using a pool and should maintain safe 

water temperatures. 
c) the counter-current of the riptide pool is extremely 

powerful and could cause injury if used incorrectly. Do not 

stand next to the counter-current nozzles when the motor is 

running. ideally, you should be placed at least 1 meter from 

the nozzles. never attempt to adjust the swim jet nozzles 

whilst the motor is running 
d) the use of alcohol, drugs, or medication, before or during 

pool use, may lead to unconsciousness with the possibility 

of drowning. 
e) Persons suffering from obesity, or with a medical history of 

heart disease, low or high blood pressure, circulatory system 

problems, or diabetes, should consult a physician before 

using a riptide pool. 
f) Persons using medication should consult a physician 

before using the pool since some medication may induce 

drowsiness while other medication may affect heart rate, 

blood pressure and circulation. 

aDDItIONaL SafEty INStRUCtIONS: 
1. WaRNING - risk of fatal hypothermia. 

a) the use of alcohol, drugs, or medication can greatly 

increase the risk of fatal Hypothermia in a pool. 
b) the causes, symptoms, and effects of Hypothermia may be 

described as follows: Hypothermia occurs when the internal 

temperature of the body reaches a level several degrees 

below the normal body temperature of 37°C (98.6°F). the 

symptoms of Hypothermia include an decrease in the internal 

temperature of the body, dizziness, lethargy, drowsiness, and 

fainting. the effects of Hypothermia include: 
• Unawareness of impending hazard; 

• Failure to perceive cold; 

• Failure to recognize the need to exit the pool; 

• Physical inability to exit the pool; 

• Foetal damage in pregnant women; and 

• Unconsciousness and danger of drowning. 

2. WaRNING - risk to infants, the elderly, and 

women planning pregnancy or during pregnancy. 

Please consult your physician if the above applies to you or 

anyone using your pool. 

3. WaRNING - risk of children drowning. 

although 

your riptide pool cover is not rated as a safety cover, it is 

wise to always keep the pool cover securely fastened when 

not in use. this will help discourage children from attempting 

to enter the pool when not supervised by an adult. 

4. WaRNING - risk of drowning. 

use caution when 

bathing alone. Overexposure to hot water may

cause nausea, dizziness, and fainting. 

5. WaRNING - risk of injury.

 always use extreme 

caution while entering or exiting the pool. surfaces can be 

very slippery when wet. Do not step or sit on head rests. 

Keep all breakable objects out of the pool area. 

6. WaRNING - risk of injury. 

never use the pool 

immediately after strenuous exercise. 

7. WaRNING - risk of injury.

 individuals with infectious 

diseases should not use the pool 

8. WaRNING - risk of injury. 

Maintain water chemistry 

in accordance with chemical manufacturer’s instructions. 

9. WaRNING - risk of shock. 

the pool must not be 

operated in severe weather conditions, i.e. electrical storms. 

10. CaUtION - unauthorised access. 

secure 

the pool area against unauthorised access. Make sure all 

barriers meet local codes. Keep the pool cover on pool when 

not being used. 

11. CaUtION - risk of damage to pool or 

equipment. 

By performing maintenance as described 

later in this Owner’s Manual, the chance of damage to your 

pool and its equipment will be greatly reduced. never block 

the air vents that lead to the equipment compartment. Doing 

so may cause the pool equipment to overheat. 

12. CaUtION - non-approved accessories. 

using 

accessories not approved by the manufacturer could void 

your guarantee or cause other problems. Please consult with 

your authorised riptide dealer. 

13. CaUtION - location of your Riptide pool. 

locate your riptide pool on a surface that can withstand 

the weight bearing requirements of the pool (see selecting 

a site for your riptide pool in this Manual). also, locate your 

pool in an environment that can withstand repeated exposure 

to water and the possibility of a major spill.

iMpORTaNT SaFETY iNFORMaTiON 

4

Summary of Contents for Nautilus 5.8





























Reviews: