19
Setup
Plug in your servos and ESC to the receiver.
Push the receiver into the fuselage under the
wing.
Turn on your transmitter and be sure that the
trims are centered.
Verify that the left servo is elevator.
Install the servo arms pointing straight down and
put the servo arm screw in.
Using the end of the pushrod you already made,
put the “Z” bend into the elevator control horn.
Slide on a piece of shrink tubing.
Put the other “Z” bend in the servo and adjust the
pushrod length so that the elevator is centered.
You can use the heat shrink to hold the wire on
the carbon while you glue it.
Once you are sure that the elevator is centered
with the radio on, carefully shrink the tubing over
the wire end.
Do not melt any of the foam structure when
shrinking the tubing… Use cardboard “shields” to
insulate the foam while heating the tubing.
Repeat for the rudder.
Hatch
Cut a bevel in the front of the hatch tongue.
Glue the hatch tongue to the rear of the hatch so
that it is centered on the sides and flush with the
rear.
Only glue about half of the forward portion of the
tongue. This allows the tongue to bend.
Summary of Contents for Sea Monkey
Page 4: ...4 5mm ESP foam parts ...
Page 5: ...5 ...
