18
Motor
Slide the leads from the ESC into the slot in the
motor pylon and into the front compartment. Slip
the ESC in there as well.
It is important that the ESC sit flat on the wing.
This puts it below the servos and out of the water
if the plane flips over.
Check to be sure that your motor matches the
bolt pattern on the ply mount. If not, drill 1/16
holes and use #2 sheet metal screws to attach it.
Attach your 8x3.8 or 8x4 slow fly prop and be
sure that it clears the fuselage.
Servos
Fit the servos.
Make sure that the servos face forward (servo
arm towards the front).
Feed the servo leads forward into the fuselage.
You may need to push the ESC down to clear the
servos.
Glue servos in place with a small drop of hot glue
at each end.
.
Battery
We use an 800 or 1000 mah 2S LiPo battery in
all of our Monkeys.
We have not found a need for any more power
than this. Most 3S setups will overpower this
airframe and destroy it.
Summary of Contents for Sea Monkey
Page 4: ...4 5mm ESP foam parts ...
Page 5: ...5 ...
