14
Glue one of the ribs to the very l
eft
end of the
wing center section
. Glue it so that it is half off
the wing. This leaves a little
“shelf” to pin the
wing tip to.
Make sure it is 90 degrees to the wing and
straight up and down.
Do not glue the other wing rib at this time!
We used medium foam safe CA and accelerator
for this job.
Glue the left wing tip the
left
side of the wing
center section.
Use the dihedral gauge and make sure that there
is no gap between the wing and the tip.
You can pin the tip in place on the rib to get a
nice joint.
We used medium foam safe CA and accelerator
for this job as well.
Do not glue the other wing tip at this time!
Summary of Contents for Sea Monkey
Page 4: ...4 5mm ESP foam parts ...
Page 5: ...5 ...
