|21
20
EN
Loosen the wing screws on all cleaning openings, as marked�
Suck the combustion residues from the flue collecting ducts and the
transition areas�
Mount the removed parts in reverse order�
Turn the lock screws on the pull-out guide upwards again, carefully
pushing the stove module into the warm-air tiled stove�
Secure the stove with the mechanical lock against unintentional
rolling out�
Note
If the mechanical lock is not in (horizontal) operating position, an
error message “stove not in position” will be displayed once power
supply has been established again�
Note
Your stove may suck in false air via incorrectly sealed cleaning
covers; this air may lead to incomplete combustion in the fire
trough and thus piling up of pellets� DANGER of FIRE!
To ensure the proper operation of your pellet stove, replace any
defect (porous, frayed) seals after cleaning and maintenance�
Cleaning the flue pipes
(annually)
Remove the flue pipes� Inspect and clean the chimney connection�
Brush off any soot and dust deposits in the fire and in the flue pipes
and vacuum�
Note
Accumulated fly ash in the flue gas channels may impair the
performance of the stove and pose a safety risk�
Combustion air - intake
If necessary, please also clean the air intake with a hoover�
Note
Only when the stove is cold! You could vacuum out embers – FIRE
RISK!
Cleaning the convection air openings
Vacuum clean any dust deposits from the convection air openings
at regular intervals�
The stove should be cleaned thoroughly prior to the start of the
heating season to prevent excess odour�
Note
To prevent your stove from overheating of the internal components,
do never cover the convection fins!
Cleaning the pellet container
Do not refill the completely empty container immediately; remove
the residues (dust, chippings etc�) from the empty container�
Checking door seal
(annually)
The condition of the seals at doors and glass should be checked at
least once a year� Repair or replace seals depending on condition�
Note
Only intact seals ensure your stove works perfectly!
Bearings
(annually)
All built-in bearings (pellet screw) should be checked� Clean or
replace bearings depending on condition�
Summary of Contents for Revivo 125
Page 1: ...Operating manual REVIVO 140 REVIVO 125...
Page 27: ...27 26 EN...
