Right Weigh 201-RTS Series, Installation And Operation Manual

Page: 9 / 32

9
The next few pages cover the operating modes that are built into the
201
- RTS Series load scale. The load scale can only be setup in one operating mode
at a time. If the mode is changed, the calibration data will be reset to factory
defaults, requiring re
- calibration.
Average Mode (AVG): This is the default mode of the scale. Both air inputs are
averaged for monitoring one axle group with two Height Control Valves (HCV).
Estimated Steer Mode Average (S - AVG): For monitoring a drive axle group with
two HCVs and also calculating an estimated steer axle weight based on the
weight ratio between the drive axle group and the steer axle.
Operating Modes
1: With the scale OFF, hold both the UP and
DOWN arrow buttons, and press the on
ON/OFF button. Release all 3 buttons. The
scale will display the current mode.
2: Press the UP arrow button to cycle
through the configuration modes. To
confirm your selection, turn the scale off by
pressing the ON/OFF button.
Changing Scale Modes: