Right Weigh 201-RTS Series, Installation And Operation Manual

Page: 15 / 32

15
A security PIN code can be added to the 201 - RTS series to prevent tampering
with the scale. It will need to be entered to change the calibration values, or to
change the PIN code. Keep a copy of the PIN code for future use. Once a PIN
has been set, it can be changed, but it cannot be removed.
Security PIN Code
Setting a PIN Code
1: With the gauge OFF, hold both the C
LOW and C HIGH buttons, then press the
ON/OFF button. Release all three buttons.
2: Press the MENU button. The display will
show
“ - - - - - ”. Enter the previous PIN code.
If the correct code was entered, The display
will show
“ Good ”.
3: Press the MENU button, and enter the
new 5 digit PIN code using buttons 1, 2, 3,
and 4. Press the MENU button again to
save the new PIN.
Changing your PIN Code
1: With the gauge OFF, hold both the C LOW
and C HIGH buttons, then press the ON/
OFF button. Release all three buttons.
2: Press the MENU button. The display will
show
“00000”. If the display shows “ - - - - - ” it
means there is already a code set. Enter in a
5 digit PIN code using buttons 1, 2, 3 and 4.
Press the MENU button again to save the
PIN.