37
TECHNICAL ASSISTANCE SERVICE
TECHNICAL ASSISTANCE SERVICE
Before proceeding with the adjustment of the door:
− Check that the pin (1)on the door slides freely in the cen-
tre of the slot on the support/centring bracket (B).
− Check that the door profile (2) rests on the support/cen-
tring bracket (B),
If one of these two conditions is not met, proceed with the ad-
justment operations described on the following pages.
2
1
B
9
The pin (1) must not be used as a handle to close the door.
Door balancing
− Loosen the screws (6) of the upper hinge and act on the
adjustment screw (7) to correct the horizontal alignment
of the door opening/closing.
− Once the operation is completed, completely tighten the
screws (6) of the upper hinge.
− Check the correct opening/closing of the door.
7
6
6
6
6
