30
INSTALLER
INSTALLER
Bottom hinge
− Loosen the nuts (1).
− Loosen the nut (2), unscrew and remove the through bolt
(3).
2
1
3
− Remove the four nuts (4), remove the bracket (5)and re-
fit it on the opposite side by reversing the sequence of
actions.
5
4
− From this side fit the plate using the nuts previously re-
moved.
9
To avoid dangerous leaks of combustion gases, the door
must be constantly and uniformly resting on the double
gaskets. For adjustment, follow the instructions in para-
3.14
Earth connection
For the earthing of the boiler body, a connection point is pro-
vided in the centre of the frame to be connected to an effective
earthing system.
Proceed as follows.
− Unscrew the nut and washer (1) from the earth terminal
− Attach the earth cable’s eye connector (2) to the terminal.
(Make sure that the cable is of adequate size and com-
plies with legislation in the country of installation)
− Fit the nut and washer (1) to the earth terminal and tight-
en the nut
− Connect the other end of the cable to the system’s earth
bar.
(*)
(**)
1
1
2
(**)
M6x30 brass
There is another hole (*) on the left side where the earthing con-
nection can be made. If you decide to use the hole on the left
side for the earthing connection, it is necessary to remove the
hardware on the right side of the hole and apply it to the left
side.
