RIDGID PC116, Manual

Page: 13 / 400

Maintenance Instructions
WARNING
Make sure that the switch is in the O-OFF position
and the machine is unplugged before performing
any maintenance or making any adjustments.
Maintain cutter according to these procedures to
reduce the risk of injury from electrical shock, entan-
glement and other causes.
Cleaning
Gently clean the machine after each use with a clean dry
cloth. Keep the rollers clean and free from dirt and debris.
Keep the reamer clean and free from chips for maxi-
mum efficiency.
Clean any dust and debris from the motor vents.
Lubrication
On a monthly basis (or more often if needed) lubricate all
exposed moving parts of Power Tube Cutter and PC116TS
stand (such as feed screw, quick feed system, rollers and
pivot points) with a light lubricating oil. Wipe any excess oil
from exposed surfaces.
Changing Cutter Wheel
See Specifications for proper cutting wheel selection.
Change the cutter wheel when cutting different materi-
als, replace the cutter wheel when the cutting edge
becomes chipped or flat. An extra cutter wheel can be
stored on the unit.
See Figure 13.
1. Remove the link pin. The wheel holder will drop free
(Figure 14) .
Figure 14 – Removing Wheel Holder
2. Remove wheel pin and cutter wheel/bearing (Figure
15) .
3. Inspect bearing. Bearing should move freely. Replace
if needed.
4. Reverse process to install cutter wheel.
Figure 15 – Changing Cutter Wheel
Motor Overcurrent Protection
The cutter is equipped with overcurrent protection that
turns off the machine to protect the motor if it draws exces-
sive current.
If the machine shuts down unexpectedly, release the
footswitch. Place the switch in the O-OFF position and
unplug the machine. Remove any tube from the machine.
Follow the
Pre-Operation Inspection and Machine and
Work Area Set-up sections to confirm that the machine
works properly.
Changing Motor Brushes
Check motor brushes every six months, the brushes
should be changed if the length is less than 5 mm (0.2").
1. Confirm that switch is in the O-OFF position and the
machine is unplugged.
2. Loosen the five screws that hold the bottom cover
(Figure 16) and remove cover (Some screws are
retained to cover).
3. Use a screwdriver to unscrew and remove the brush
caps (Figure 17) . Gently remove the carbon brushes
and check the length (Figure 18) . If brush length is
less than 5 mm (0.2"), change brushes.
4. Insert brush into brush holder, properly aligning the
brush tabs with the reliefs in the brush holder.
5. Securely tighten the brush caps. Reinstall the bottom
cover.
6. Once the machine is reassembled, run the machine in
the II-High speed for five minutes with no tube in the
machine to break in the brushes.
944-732-258.09_REV C 11
PC116/PTC-400 Power Tubing Cutter
Bearing
Cutter
Wheel
Wheel
Holder
Link Pin
Wheel Pin