RIDGID micro CA-300, Operator'S Manual

Page: 10 / 464

micro CA-300 Inspection Camera
8
Figure 6 - Removing/Installing Battery
2. Insert contact end of battery into the in-
spection tool, as shown in Figure 6 .
3. Replace battery compartment cover.
Powering with the AC Adapter
The micro CA-300 Inspection Camera can al-
so be powered using the supplied AC Adapt-
er.
1. Open the right side port cover (
Figure 3 ).
2. With dry hands, plug the AC adapter into
the outlet.
3. Insert the AC adapter barrel plug into the
port marked “DC 5V”.
Figure 7 - Powering the Unit with AC
Adapter
Installing the Imager Head Cable
or Extension Cables
To use the micro CA-300 Inspection Cam er a,
the imager head cable must be connected to
the handheld display unit. To connect the ca-
ble to the handheld display unit, make sure
the camera socket key and display unit sock-
et slot ( Figure 8 ) are properly aligned. Once
they are aligned, finger tighten the knurled
knob to hold the connection in place.
Figure 8 - Cable Connections
3’ (90 cm) and 6’ (180 cm) cable extensions
are available to increase the length of your
camera cable up to 30 feet (9 meters). To in-
stall an extension, first remove the camera
head cable from the display unit by loosen-
ing the knurled knob. Connect the extension
to the handheld as described above ( Figure
8 ). Connect the keyed end of the camera
head cable to the slotted end of the exten-
sion and finger tighten the knurled knob to
hold the connection in place.
Installing Accessories
The three included accessories, (Hook, Mag-
net, Mirror) all attach to the imager head the
same way.
To connect, hold the imager head as shown in
Figure 9 . Slip the semicircle end of the acces-
sory over the flats of the imager head. Then
rotate the accessory a 1/4 turn to retain.
Figure 9 - Installing an Accessory
Accessory
Installing SD™ Card
Open the left side port cover ( Figure 4 ) to ac-
cess the SD card slot. Insert the SD card into
the slot making sure the contacts are facing
towards you and the angled portion of the
card is facing down ( Figure 10 ) . SD cards can
only be installed one way – do not force.
When an SD card is installed, a small SD card
icon will appear in the bottom right hand
portion of the screen, along with the num-
ber of images or length of video that can be
stored on the SD card.