RIDGID EB4424, Operator'S Manual

Page: 12 / 36

12
Assembly
NOTE: The sander is preassembled
except for the attachment of the rubber
feet.
Mounting Rubber Feet To Base
Place the sander directly on the table sur-
face.
1. From the parts bag locate the four rub-
ber feet.
2. Place the sander on its side so the bot-
tom of the base is facing toward the
front.
3. Locate the four holes in each corner of
the base and place one of the rubber
feet in each of these holes.
4. Position sander in the upright position
and apply pressure in the downward
position to ensure the feet are inserted
securely.
CAUTION: To reduce the risk of
injury from tool movement, the
supporting surface where sander
is mounted should be examined
carefully after mounting to insure
no movement during use can
result. If any tipping or walking is
noticed, secure to workbench or
supporting surface before oper-
ating sander.
Parts Storage
On board storage has been provided for
all washers, spacers, drums, sleeves and
hex “L” wrenches. All front loaded parts
can be protected from incidental dislodg-
ing by lowering the table all the way down
until it rests against the base and tighten-
ing the knob.
Storage for the sanding belt assembly and
table insert is provided in the pocket on
the rear of the base.
Rubber Feet