RIDGID 11-R, Manual

Page: 8 / 80

999-995-242.10_REV A
6
760 FXP Power Drive
Icon
Blinking Solid
Meaning
Light Light
Blue Connection to RIDGID Link app possible.
Blue Connection to RIDGID Link app established.
Green Nearing the end of thread for
1
/
2
" - 2" NPT. User
should pay closer attention to the die head area as
the completion of the thread is nearing. LED work
light will also vary in brightness.
Yellow Battery charge is low and only limited number of
threads remain before battery must be recharged
(can only thread about 3 2” threads or 4-5 1” threads
on remaining charge).
Yellow Battery low and tool will not operate. Recharge
Red battery/insert fully charged battery.
Yellow Maintenance is required. Consult RIDGID Link app
for more information.
Red Tool has stopped due to an event exceeding usable
limits (e.g. current, temperature, or stability). Confirm
proper set-up and restart use. Consult RIDGID Link
app for more information.
Red Tool has malfunctioned and will not operate. Remove
battery and allow tool to rest, then reinsert battery.
If light still ON, have tool serviced. Consult RIDGID
Link app for more information.
Purple Firmware update in process, tool cannot be used
while updating. Consult RIDGID Link app for more
information.
Purple Firmware update was interrupted and not completed,
Red tool cannot be used. Continue and complete update
per app instructions.
Left Hand
Threads ............ Yes with Appropriate Die Head
Support Arm ..... No. 692
Power Supply ... RIDGID RB-FXPXX Battery Pack
(See Optional Equipment Section )
Motor Type ....... Brushless DC Motor
Watts ................ 1080 W
Voltage ............. 54V DC nominal
Amps ................ 20 A
Operating Speed
(RPM) ............... 42 RPM, No load
Controls ............ Forward/Reverse Slide Switch and
ON/OFF Momentary Contact Switch
Gear Head ....... Die Cast Aluminum, Permanently
Greased
Operating
Temperature ..... -4°F to 140°F (-20°C to 60°C)
Storage
Temperature ..... -4°F to 140°F (-20°C to 60°C)
Specifications
Pipe Threading
Capacity ........... Pipe 1/8" to 2" (3 to 50 mm)
Bolt 1/4" to 1" (6 to 25 mm) with 00-RB
Die Head
Model ............... 760 FXP 11-R 760 FXP 12-R
Die Head
Holding 11-R Die Head 12-R Die Head
Retaining Retaining
Mechanism Mechanism
(1 ½ – 2 inch)
Ring Spring
(1/8 – 1 ¼ inch)
Die Type ........... High Speed Dies Recommended
#
Oil Type .............RIDGID Nu-Clear™, Endura-Clear™
or Extreme Performance™ Thread
Cutting Oil Recommended #
Adapter ..............Used with Not Required
1/8" - 1¼"
Die Heads
Figure 4 – Tool Status Lights