3.5 Identification
This product manual is only applicable to:
•
Ridder RB50Eᵖˡᵘˢ tube motors (2016)
•
Serial numbers from 200.900.000
•
Item numbers: 550032
550037
550039.
Identification is possible from the sticker on the location shown. Refer
to the explanation that follows on how to read the information. For
more information on item numbers and models refer to the Ridder
catalogue or website
www.ridder.com
.
4. INSTALL INSTRUCTIONS
4.1 Special tools and equipment
Ê
EXAMPLE
B50: Diameter of the tube motor in mm
VK10: Journal dimensions in mm (10x10)
Alternatives: P20 - width in mm
50: Mains frequency 50 Hz
230: Mains voltage 230 V
3.5: Number of revolutions drive shaft at 50 Hz
E+: Tube motor with electronic limit-switch
50: Torque RB tube motor in Nm
RB: General designation Ridder tube motors
L772: Length (l) of the tube motor in mm
Alternatives: 846 mm
Make sure that the correct equipment and tools are used.
During mechanical installation an adjusting switch can be used, if
necessary, to operate the tube motor.
§7.2 gives more information about the adjusting switch.
Ridder Drive Systems
T
+31 (0)341 416 854
F
+31 (0)341 416 611
I
www.ridder.com
9
Summary of Contents for RB50EPLUS
Page 36: ...www ridder com...
