4.4 Attach the tube motor to the guiding unit
Attach the cable-carrier bracket (8) to the guiding unit (2)
at the same time
as the tube motor (1).
Refer to view B-B. Refer to view
C-C
if the installation is on the
other side
of the roller screen.
Do the procedure that follows.
1.
Align the hole of ø 4 mm (for the split pin 19) with the opening 2.2.
2.
Put the cable-carrier bracket (8) in position with the long side pointed to the guiding unit (2).
3.
Put the power cable of the tube motor (1) along the long side of the cable-carrier bracket (8).
4.
Move the head (10x10) of the tube motor (1) through the bottom hole (8.1) of the cable-carrier
bracket (8).
5.
Put the head of the tube motor (1) fully into the hole (10x10) of the attachment bracket (2.1) of
the guiding unit (2). At this time the cable-carrier bracket (8) is also put in the correct position.
6. Put the split pin (19) in the hole of ø 4mm.
7. Use the split pin (19) and safety the assembly.
(C-C)
(C-C)
4.4.1
Ridder Drive Systems
T
+31 (0)341 416 854
F
+31 (0)341 416 611
I
www.ridder.com
16
Summary of Contents for RB50EPLUS
Page 36: ...www ridder com...
