Do the procedure that follows.
1.
Pull the cord (20.1 of the screen cloth) through the groove, in the direction of the end (on the
coupling piece) of the winding tube (17). Refer to illustration 4.7.3.
2.
Continue to pull the cord (20.1) until the distance, from the end of the winding tube (17), is
equal to
l2
(
l minus 40 mm
).
Note:
Keep the minimum distance of 40 mm free between the screen cloth (20) and the head of
the tube motor. This makes sure the guiding system can move freely during wind up if the screen
cloth is not cut straight. Refer to illustrations 4.7.1/4.7.5
3.
Cut along the cutting line (l3) at the distance of L2 from the end of the screen cloth (20). Make
an estimate of the length of l3. Refer to illustrations 4.7.1/4.7.3.
4.
Cut and discard the cord (20.1) along the distance of L2 of the screen cloth (20.2). Refer to
illustrations 4.7.1/4.7.4.
5.
Make sure that the winding tube (17) is put against the tube (1.1). For the four recommended
drilling positions (d) in the winding tube (17) and the coupling piece (16) refer to illustrations
4.7.5/G-G.
6. Drill one of the holes for the pop-rivets (18) into the winding tube (17) and coupling piece (16)
(minimum of ø5.2 mm if pop-rivets of ø5 mm are used).
7. Use a pop-rivet pliers to attach the pop-rivet (18).
8. Drill the holes for the other three pop-rivets (18).
9. Use the pop-rivet pliers to attach the other three pop-rivets (18).
4.7.3
4.7.4
4.7.5
G-G
d (4x)
25 75
G
G
40
Ridder Drive Systems
T
+31 (0)341 416 854
F
+31 (0)341 416 611
I
www.ridder.com
21
Summary of Contents for RB50EPLUS
Page 36: ...www ridder com...
