4
Installation
This section is intended for the dealer of the HortiJet-Go!.
This section describes the following subjects:
Installation requirements
Connecting the various components
In section "Step-by-step installation and commissioning instructions" on
page 26 you will find an overview of the steps. Use the Bijlage: "Checklist for
step-by-step installation procedure" on page 62 to check that all steps have
been completed.
4.1
Installation requirements
This section describes the requirements for installing the HortiJet.
4.1.1
Dealer/installer requirements
The installation of the HortiJet-Go! and the other components, together with the
installation and configuration of the software, must be carried out by a qualified
dealer. Ridder Growing Solutions considers a dealer/installer to be qualified if that
person meets the following requirements:
The dealer:
has a broad knowledge of installation technology (hydronic and electronic).
can understand and carry out instructions in English.
is familiar with the contents of this installation and user manual.
4.1.2
Installation requirements
The following requirements apply to installing the HortiJet-Go! on site:
Make sure that the HortiJet-Go! is level.
Install the HortiJet-Go! on a hard surface that is able to support its weight.
Install the unit in a dry, dust-free location (1)
1
.
Check the ambient temperature. This should be between 5°C - 30°C (41°F -
86°F) (2).
Check the relative humidity (RV). This may not exceed 85%, without
condensation (3).
Make sure that the unit is not exposed to dripping or splashing water (4).
Avoid exposure to direct sunlight (5).
Avoid exposure to hazardous substances (6).
Avoid exposure to unnecessary vibrations (7).
1
The numbers refer to the numbers in Figure 4-1.
HortiJet-Go!
23