PTCS-7S Computerized Embroidery Machine Operation Manual V2.1
43
Stop Frame of
Moving:
Allow drawing bar stop or not when beyond the hoop
Yes
Yes, No
Return offset
automatically
Deliver to highest position of hoop automatically or not
after embroidery is completed.
No
Yes, No
N*
Embroidery machine using needle bar number (no default value)
*
Set according to requirements (no default value)
22. 2 System Errors and Countermeasures List
Errors
Fault Causes
Countermeasures
Spindle is not at 100
degree
Spindle is not stopped at 100 degree
Jogging or manually rotated spindle to 100
degree
Spindle is not rotated 1.Spindle controller has no signal or
power input
2. Spindle motor has no signal or power
input
3.Controller or spindle motor damage
4.Encoder is not connected
1.Check spindle controller or power wire
2.Check spindle motor input power
3.Replace controller or motor
4.Connect encoder properly
Reverse rotation of
spindle
1.Reverse connection or encoder A/B
1.Adjust phase wire of encoder A/B
Over time for color
changing
1.Color changing motor does not rotate
2.Mechnical
part
seizing
of
color
changing
3.Wiring cable fault from color changing
motor to power panel
1.Check
color
changing
machine
or
connection cable
2. Repair or replace seized mechanical part
3. Check or replace connection cable
No stitch
1.stict detection sensing wheel position
error
2. Stitch detection board damage
1.Adjust stitch sensing wheel position
2. Replace detection board
XY motor driver error
1.Over-voltage or over current protection
of driver
1.Check driver input power and re-powering
on
