PTCS-7S Computerized Embroidery Machine Operation Manual V2.1
17
Backward position: After pressing
key, a keyboard pops out. Press number
key to input required backward position in stitch count. Press
key and the hoop is
moved to specified stitches and stopped automatically.
Going forward one color: After pressing
key, the cross section is moved to the start
position of following color and stops automatically.
Backing one color: After pressing
key, the cross section is moved to start
position of previous color and stops automatically.
4.3-9 Embroidery Design Trace Operation
The embroidery Design Trace Operation is use to check the location of the design. After the
embroidery design origin is set, press
key to initialize the trace function. A pop-up
will appear saying “Enter Embroidery Status” press ok. If design location is not in the place
needed, try again until satisfied.
Embroidery Design Trace Contour Operation
After setting start point and tracing the design, a new option will appear on the right side of
the trace icon, press
key and the hoop will start to move slowly, outlining the
design with more precision from start point along the contour (precise range). After the trace
contour is finished, it returns to starting point automatically.
4.3-10 Returning to Embroidery Origin Point after Power Failure
The operation is mainly applied when sudden power failure occurs in embroidering process
and when the hoop appears out of place.
When the hoop type is “Other”, this operation is only valid when absolute origin of
hoop is searched before embroidering.
In operation status, press
key to enter into machine menu interface. Press
key and the system prompts “Press OK to start searching absolute origin”. Press
key
to start searching absolute origin. Then the hoop is moved to embroidering position before power
failure and stops.
